Search
You can find the results of your search below.
Fulltext results:
- Panel Meter Interface
- re shutdown| |7|AVss|Analog ground| |8|VoutA|DACa Output| **PIC Assembly Code** <code asm> SPIclk macr... endm ;Setup direction BCF TRISB,RB1 ; RB1 as Output BCF TRISC,SCL ; SDO as Output BCF TRISC,SDA ; SCK as Output ;Set initial pin states BSF PORTB,RB1 ;Chip Select, active low BCF
- Stepper motor driver
- _con.jpg?400|}} ^DB9^Connection^ |1|L298-Pin14-Output 4| |2|L298-Pin13-Output 3| |3|L298-Pin3-Output 2| |4|L298-Pin2-Output 1| |5|Ground?| |6|Logic?| |7|Logic?| |8|Logic?| |9|Logic?| ====== Stepper 2 ====
- Tire Pressure Sensor Code @projects:electronics:tirepressuresensor
- ********************** Bin_Out macro Floc ; Output a Binary Value variable i i = 0 while i < 8 ... movf _Error,F,A ; If _Error is set, change output to --- btfsc STATUS,Z goto noerr MOVLW S... nk movf _Error,F,A ; If _Error is set, change output to --- btfsc STATUS,Z goto No_Error movl... r: 0 % ; Input: Mult0 .. Mult1, 10 bits ; Output: Mult0 .. Mult2, 18 bits ; Code size: 45 instruct
- 50 Amp 5 Volt Power Supply
- |}} Need a 208.76 ohm, 1% resistor to set the 5V output. Right now I'm using a 500 ohm potentiometer. 200 ohms would output 5.02V. {{:projects:electronics:50a5vpowersupply:
- Relay board
- _details.aspx?cid=4&item=G4ODC5|G4 ODC5]] - G4 DC Output 5-60 VDC, 5 VDC Logic * [[http://www.opto22.com... _details.aspx?cid=4&item=G4OAC5|G4 OAC5]] - G4 AC Output 12-140 VAC, 5 VDC Logic Want * [[http://www.opt
- GPS
- mate Hyperformance GPS Receiver - Rockwell binary output only * [[http://byonics.com/gst-1/|GST-1 GPS
- IO Board
- Board ====== 16 Bit Digital input, 16 Bit Digital Output. {{:projects:electronics:ioboard:io_board.jpg?60